"sfc /scannow" reports errors after NTLite image is installed

[Jkin_2k]

Hello community,

my NTLite Image causes "sfc /scannow" to display errors right after I run this command after installation.

Please see the attached CBS.log for details - I am not experienced with reading this log, your help would be appreciated.

In my NTlite Image there's the following integrated:

- automatic start into AUDIT mode after install
- drivers
- windows updates
- one oem-logo jpg-file placed into C:\Windows\

Thank you for your thoughts and analysis!

 

[nuhi]

Hi,

I would need the NTLite preset demonstrating the issue, including which updates were used if not visible from the preset.

If just integrating updates, then it's a Windows bug, wouldn't be the first time.
But for example if using Custom Update Cleanup by NTLite, then it might be in a need of a fix.

Also if removing Cumulative Update cache (LCU), try keeping it.

Thanks.

 

[Jkin_2k]

I would need the NTLite preset demonstrating the issue, including which updates were used if not visible from the preset.

I added the preset to this post
All the updates that were offered by NTLite were used - I will try to do a new run and take a screenshot.

If just integrating updates, then it's a Windows bug, wouldn't be the first time.
But for example if using Custom Update Cleanup by NTLite, then it might be in a need of a fix.

I will look further into this, I do not know if this feature was enabled.

Also if removing Cumulative Update cache (LCU), try keeping it.

ok, I will report back later, I also don't recall using this feature.

Thank you very much, nuhi!

 

[nuhi]

Hi,

that preset just has driver insertion, that would not influence this.
Anyway while recreating, make sure to store all of the presets if doing changes in multiple sessions.

 

[Jkin_2k]

Hello again,
the problem persists. I will try removing the applied windows updates one by one.
This preset here should have the complete information on applied things.
Maybe this screenshot helps:

 

[Jkin_2k]

Update: Even without integrating windows updates "sfc /scannow" reports errors.