ISO can't continue installing at 2nd stage

tacc2000

New Member
Successfully created ISO(by NTlite1.9.0.7428) can't continue installing after 2nd stage(just after 2nd boot)
(Just a little circle going round and round forever)

Of course, source ISO from Microsoft Win10_1909_Japanese_x32.iso can finish installing successfully.
Any info welcomed.
 

garlin

Active Member
If you install other apps, check if your Post-Setup commands need a flag for quiet or unattended install.
 

Kasual

Well-Known Member
Of course, source ISO from Microsoft Win10_1909_Japanese_x32.iso can finish installing successfully.
Any info welcomed.
 

tacc2000

New Member
If you install other apps, check if your Post-Setup commands need a flag for quiet or unattended install.
Thank you for your reply. Umm, I don't install any apps by NTlite.
Can't ISO file created by free version of NTlite install successfully?
 

garlin

Active Member
Next step is to share your saved preset with us. Please remove any lines with passwords or license key first.
 

garlin

Active Member
Cortana is enabled, but you removed three components it cares about. Restore the two network components.

OOBENetworkCaptivePort
OOBENetworkConnectionFlow
ParentalControls

See this table.
CortanaMicrosoft.Windows.CortanaxxxNo
Microsoft.Windows.Holographic.FirstRunxxNo
Microsoft.Windows.OOBENetworkCaptivePortxxxNo
Microsoft.Windows.OOBENetworkConnectionFlowxxxNo
Microsoft.Windows.ParentalControlsxxxNo
 
Last edited:

garlin

Active Member
I think Out of Box Experience setup is also stuck because it can't ask to configure your network.
 

tacc2000

New Member
Cortana is enabled, but you removed three components it cares about. Restore the two network components.
Setting Cortana to "no" in my preset, I installed successfully(^o^) Thank you very much.

Another problem occurs, after [Sign in] as administrator, DeskTop screen and black screen are displayed alternately!
Is my preset wrong?
 

Attachments

garlin

Active Member
You turned off all the Components in this preset, that's too many! Use the Reset button on the Components page to start over.
 

tacc2000

New Member
At 3rd stage(after Sign in) in installation by successfully created ISO, blue DeskTop screen and black screen comes out alternatively.
Too many components removed?
 

Attachments

Top