Ceyarrecks
Member
I think I have found my error in a previous preset install.
But to assure I do not make any assumptions in the NTLite process; Exactly how do I run the exact same preset as was Auto-Saved,
but make ONE change to its settings (in this case not remove a specific component) yet keep everything else?
Would it be:
[have "fresh" OEM/Disk install files in nearby directory]
[have patches also in nearby directory]
[launch NTLite]
[dismount ALL old images/directories]
[mount fresh image directory]
[load previous Auto-Saved preset]
[dig down into settings and remove(or add) check to indicate component removal]
[go to end, make new .iso file name]
[run process...]
This process feels familiar, as does the foreboding that having done so many times in past and not having met with success,...
But to assure I do not make any assumptions in the NTLite process; Exactly how do I run the exact same preset as was Auto-Saved,
but make ONE change to its settings (in this case not remove a specific component) yet keep everything else?
Would it be:
[have "fresh" OEM/Disk install files in nearby directory]
[have patches also in nearby directory]
[launch NTLite]
[dismount ALL old images/directories]
[mount fresh image directory]
[load previous Auto-Saved preset]
[dig down into settings and remove(or add) check to indicate component removal]
[go to end, make new .iso file name]
[run process...]
This process feels familiar, as does the foreboding that having done so many times in past and not having met with success,...
Last edited: