"sfc /scannow" reports errors after NTLite Image is installed

Jkin_2k

New Member
Hello community,

my NTLite Image causes "sfc /scannow" to display errors right after I run this command after installation.

Please see the attached CBS.log for details - I am not experienced with reading this log, your help would be appreciated.

In my NTlite Image there's the following integrated:

- automatic start into AUDIT mode after install
- drivers
- windows updates
- one oem-logo jpg-file placed into C:\Windows\

Thank you for your thoughts and analysis!
 

Attachments

nuhi

NTLite developer
Staff member
Hi,

I would need the NTLite preset demonstrating the issue, including which updates were used if not visible from the preset.

If just integrating updates, then it's a Windows bug, wouldn't be the first time.
But for example if using Custom Update Cleanup by NTLite, then it might be in a need of a fix.

Also if removing Cumulative Update cache (LCU), try keeping it.

Thanks.
 

Jkin_2k

New Member
I would need the NTLite preset demonstrating the issue, including which updates were used if not visible from the preset.
I added the preset to this post
All the updates that were offered by NTLite were used - I will try to do a new run and take a screenshot.
If just integrating updates, then it's a Windows bug, wouldn't be the first time.
But for example if using Custom Update Cleanup by NTLite, then it might be in a need of a fix.
I will look further into this, I do not know if this feature was enabled.
Also if removing Cumulative Update cache (LCU), try keeping it.
ok, I will report back later, I also don't recall using this feature.

Thank you very much, nuhi!
 

Attachments

nuhi

NTLite developer
Staff member
Hi,

that preset just has driver insertion, that would not influence this.
Anyway while recreating, make sure to store all of the presets if doing changes in multiple sessions.
 
Top