Need some guidance on this topic.
I have added the RAID drivers in the driver section and checked winre.wim, install.wim and boot.wim 1 & 2 in the Reapply tasks across editions sections.
I think this should do the trick. But when starting the installation process I end up being stuck at the part where I need to select the disk for installation. I see two disks as opposed to the single RAID0 array/disk.
Now if I load the RAID drivers manually at this stage I have the desired outcome and RAID0 array/disk is properly recognised.
Did I miss something in my setup?
Many thanks in advance.
I have added the RAID drivers in the driver section and checked winre.wim, install.wim and boot.wim 1 & 2 in the Reapply tasks across editions sections.
I think this should do the trick. But when starting the installation process I end up being stuck at the part where I need to select the disk for installation. I see two disks as opposed to the single RAID0 array/disk.
Now if I load the RAID drivers manually at this stage I have the desired outcome and RAID0 array/disk is properly recognised.
Did I miss something in my setup?
Many thanks in advance.